Käyttöopas Briggs & Stratton Kytkin 01813-1 [10/44 Sivut]

Briggs & Stratton kytkin 01813-1

Briggs & Stratton Power Products Automatic Transfer Switch

Installation and Operator’s Manual

SYSTEM OPERATION

To select automatic transfer operation, do the following:

1A. For models 01813-1 & 01814-1, set service disconnect

switch that sends utility power to transfer switch

contactor to “On” position.

B. For models 01928-1 & 01929-1, set service disconnect

switch that sends utility power to transfer switch utility

disconnect circuit breaker to “On” position.

2. For models 01928-1 & 01929-1, set transfer switch

utility disconnect circuit breaker to “On” position.

3. Set generator’s main circuit breaker to its “On”

position.

4. Install 15 Amp fuse in control panel on generator.

5A. If generator is equipped with a system ON/OFF

switch, set switch to “On” position.

B. If generator is equipped with a AUTO/OFF/MANUAL

switch, set switch to “AUTO” position.

The system will now be in automatic operation mode.

TESTING THE

AUTOMATIC TRANSFER

SWITCH

Turn the service disconnect feeding the transfer switch, to

the “Off” position.The automatic sequence will follow.To

go back to utility power, turn the service disconnect to the

“On” position.

Automatic Sequence

Utility Fail

The Home Standby Generator set senses when utility

voltage is below 70 percent of nominal. Engine start

sequence is initiated after 6 second time delay.

Engine Warm-Up

Time delay to allow for engine warm-up before transfer

fixed at 20 seconds or 50 seconds with removal of jumper

on control board.

Transfer

Transfer from utility to standby supply occurs after standby

voltage is above set levels. Minimum engine run time is

5 minutes after transfer.

Utility Pickup

Voltage pickup level is 80 percent of nominal voltage.

Retransfer

Retransfer from standby to utility supply is approximately

10 seconds after utility voltage supply is above pickup level

and minimum run time is completed.

Engine Cool Down

Engine will run for 60 seconds after retransfer.

When Calling the Factory

Before contacting Briggs and Stratton Power Products

regarding service or repair of this transfer switch, obtain

the Model Number and Serial Number from the unit data

decal located on or inside the case.

To contact Briggs and Stratton Power Products call

1-800-743-4115, between 8:00 AM and 5:00 PM CT.

kasikirjatvaltameri.fi

Tietoa

Briggs & Stratton kytkin 01928-1

Briggs & Stratton kytkin 01814-1

Briggs & Stratton kytkin 01813-0

Briggs & Stratton kytkin 01814-0

Briggs & Stratton kytkin 71011

Briggs & Stratton kytkin 01929-1

Briggs & Stratton kytkin CH10EGNSYS

Briggs & Stratton kytkin 50A NEMA 3R

Briggs & Stratton kytkin CH6EGNSYS

Briggs & Stratton kytkin 695062

Briggs & Stratton kytkin 100

Briggs & Stratton kytkin 695061

Briggs & Stratton kytkin Switch

Briggs & Stratton kytkin 071037

Briggs & Stratton kytkin 71010

kasikirjatvaltameri.fi

Tietoa